Ukraine 11 клас Physics
Chapters: 4
1. Electrodynamics
Direct current circuits · Current in various media · Semiconductors · Magnetic field · Magnetic properties of matter · Electromagnetic induction
- Ohm's Law, Resistivity and Effect of Temperature – Using drift velocity, V = IR with R = ml/(ne²τA) = ρl/A. Resistivity ρ = m/(ne²τ) depends only on the material and temperature; conductivity σ = 1/ρ. Ohm's law in vector form is j = σE. Metals, wires and resistors give a straight V–I line (ohmic); bulbs, diodes and devices like GaAs give curved or one-way graphs (non-ohmic). For metals ρ rises with temperature: ρT = ρ0[1 + α(T − T0)]; alloys like nichrome change very little; semiconductors get lower ρ when hot.
- Semiconductors and the p-n Junction Diode – A semiconductor has a small energy gap (about 1 eV), so a little heat frees some electrons. Pure silicon is intrinsic (electrons = holes). Adding a 5-valence atom makes n-type; a 3-valence atom makes p-type. Joining p and n makes a junction with a depletion layer and a barrier (about 0.7 V for Si). The diode conducts in forward bias, almost not in reverse bias, so it can change AC into one-way DC (rectifier).
- Magnetic Field due to a Current: Biot-Savart Law and Ampere's Law – A current makes a magnetic field around it (Oersted, 1820). The Biot-Savart law gives the field of a tiny piece of wire: dB = (μ₀/4π)·I dl sinθ / r². Adding all pieces of a circular loop gives B = μ₀NI / 2R at the centre and μ₀NIR² / 2(R² + x²)^{3/2} on the axis. Ampere's circuital law ∮B·dl = μ₀I gives B = μ₀I / 2πr for a long straight wire. A long solenoid has a strong, uniform field B = μ₀nI inside and almost none outside.
- Magnetism and Matter – A bar magnet behaves like a solenoid: tiny current loops of electrons inside it line up. Its field on the axis (2m/r³ form) is twice the field on the equator at the same distance, and points the other way. In a uniform field a magnet feels a torque τ = m × B that turns it to line up with B. Field lines are closed loops that never cross. Materials react differently: diamagnetic ones are pushed out of a field (χ small and negative), paramagnetic ones are pulled in weakly (χ small and positive), ferromagnetic ones are pulled in strongly (χ very large). Magnetisation M is the magnetic moment per unit volume; B = μ₀(H + M), χ = M/H, μᵣ = 1 + χ. Heating reduces magnetism: paramagnets follow Curie law χ = C/T, and a ferromagnet turns paramagnetic above its Curie temperature.
- Electromagnetic Induction – When the magnetic flux through a coil changes, an emf is produced in it: ε = −N dΦ/dt (Faraday). The minus sign is Lenz's law: the induced current always opposes the change that made it. Moving a rod in a field gives motional emf ε = Blv. A changing current makes an emf in its own coil (self-induction, L) and in a nearby coil (mutual induction, M).
- Force on a Current-Carrying Conductor, Motor and Induction – A wire carrying current inside a magnetic field feels a push. The push is biggest when the wire is at 90° to the field and zero when it is parallel. Fleming's left-hand rule gives its direction. A motor uses this push to spin a coil; a generator does the reverse and makes current by moving a coil or magnet.
2. Electromagnetic oscillations and waves
LC oscillations · Alternating current · Electromagnetic waves and communication
- LC Oscillations – An LC circuit is a capacitor (C) joined to a coil (L). A charged capacitor pushes current through the coil; the coil keeps the current going and charges the capacitor the other way. Energy swings between the electric field of the capacitor and the magnetic field of the coil. With no resistance the swing never stops. Its period is T = 2π√(LC) (Thomson formula) and its frequency is f = 1 / (2π√(LC)). Resistance makes the oscillations damped; a generator with a transistor tops up energy to keep them going.
- Alternating Current – An alternating current (AC) changes size and direction again and again: I = I₀ sin ωt. Its rms value is I₀/√2, the steady DC that gives the same heating. A resistor keeps V and I in step; an inductor makes I lag by 90° (Xʟ = ωL); a capacitor makes I lead by 90° (Xᴄ = 1/ωC). In a series LCR circuit Z = √(R² + (Xʟ − Xᴄ)²), resonance happens when Xʟ = Xᴄ, and average power is P = Vrms Irms cos φ.
- Force on a Current-Carrying Conductor, Motor and Induction – A wire carrying current inside a magnetic field feels a push. The push is biggest when the wire is at 90° to the field and zero when it is parallel. Fleming's left-hand rule gives its direction. A motor uses this push to spin a coil; a generator does the reverse and makes current by moving a coil or magnet.
- Electromagnetic Waves – A changing electric field acts like a current, called the displacement current, and it makes a magnetic field. A changing magnetic field makes an electric field. Together they travel as an electromagnetic (EM) wave at c = 3 × 10⁸ m/s, even through empty space. E and B are at right angles to each other and to the direction of travel, so EM waves are transverse. Sorted by wavelength, they form the spectrum: radio, microwave, infrared, visible, ultraviolet, X-rays and gamma rays.
3. Optics
Geometric optics · Wave optics · Quantum properties of light · X-rays and EM spectrum
- Thin Lenses: Lens Maker's Formula, Lens Formula and Power – At one curved surface, n₂/v − n₁/u = (n₂ − n₁)/R. Two such surfaces make a thin lens with 1/f = (n − 1)(1/R₁ − 1/R₂) (lens maker's formula). Object and image distances follow 1/v − 1/u = 1/f, magnification m = v/u, power P = 1/f (in dioptres when f is in metres), and thin lenses in contact add their powers: P = P₁ + P₂.
- Interference (Young's Double Slit) and Single Slit Diffraction – Two coherent sources (same frequency, fixed phase difference) make a steady pattern of bright and dark fringes. At a point on the screen the path difference is Δ = yd/D: bright where Δ = nλ, dark where Δ = (n + ½)λ. All fringes have equal width β = λD/d. A single slit of width a gives diffraction: a bright central maximum of width 2λD/a, with first minima where a sin θ = λ, and weaker side maxima.
- Photoelectric Effect and Einstein's Equation – When light of high enough frequency falls on a metal, electrons jump out at once. Light comes in packets called photons, each with energy E = hν. One photon gives all its energy to one electron: hν = φ + KEmax, where φ is the work function. Below the threshold frequency ν₀ = φ/h no electron comes out, however bright the light.
- Electromagnetic Waves – A changing electric field acts like a current, called the displacement current, and it makes a magnetic field. A changing magnetic field makes an electric field. Together they travel as an electromagnetic (EM) wave at c = 3 × 10⁸ m/s, even through empty space. E and B are at right angles to each other and to the direction of travel, so EM waves are transverse. Sorted by wavelength, they form the spectrum: radio, microwave, infrared, visible, ultraviolet, X-rays and gamma rays.
4. Atomic and nuclear physics
Atom models and spectra · Atomic nucleus · Radioactivity · Nuclear energy · Elementary particles
- Atoms: From Alpha Scattering to the Bohr Model – Rutherford shot alpha particles at thin gold foil and found that an atom is mostly empty, with a tiny, heavy, positive nucleus in the middle. Bohr then said the electron in hydrogen can move only on fixed orbits where its angular momentum is nh/2π. In orbit n the radius is 0.529 n² Å, the speed is (2.19 × 10⁶)/n m/s and the energy is −13.6/n² eV. When the electron jumps down, the energy difference comes out as light of one exact colour, which gives the line spectrum of hydrogen.
- Nuclei: Size, Nuclear Force, Binding Energy, Fission and Fusion – A nucleus is made of Z protons and N neutrons (A = Z + N nucleons). Its radius is R = R₀A^(1/3) with R₀ ≈ 1.2 fm, so every nucleus has almost the same huge density. A very strong, short-range nuclear force holds the nucleons together. The nucleus weighs a little less than its loose parts; this mass defect Δm is the binding energy, E = Δm c² (1 u = 931.5 MeV). Binding energy per nucleon is highest near iron (A ≈ 56), so heavy nuclei give energy when they split (fission) and light nuclei give energy when they join (fusion).
- Radioactivity: Alpha, Beta, Gamma and Half-Life – Some atomic nuclei are unstable. They give out radiation at random to become more stable. This is radioactive decay. Alpha (2 protons + 2 neutrons), beta (a fast electron) and gamma (a wave of energy) are the three main kinds. Half-life is the time for half of the unstable nuclei to decay.
- Particle Physics: Quarks, Leptons and the Standard Model – Particle physics studies the smallest building blocks of matter. Protons and neutrons are made of quarks. Electrons belong to a family called leptons. Every particle has an antiparticle. Particles feel four forces, and three of them are carried by messenger particles called bosons. All of this together is called the Standard Model.